| VERTICAL |
| Channels | 4 |
| Bandwidth | DC ~ 60MHz （-3dB） |
| Rise Time | 5.8ns Approx. |
| Sensitivity | 2mV/div ~ 5V/div （1-2-5 increments） |
| Accuracy | ∮（3% x |Readout|+0.05 div x Volts/div+0.8mV） |
| Input Coupling | AC, DC & Ground |
| Input Impedance | 1M∮2%, ~16pF |
| Polarity | Normal & Invert |
| Maximum Input | 300V （DC+AC peak）, CATII |
| Waveform Signal Process | + , - , FFT |
| Offset Range | 2mV/div ~ 20mV/div : 0.5V ; 50mV/div ~200mV/div: 5V ; 500mV/div ~ 2V/div : 50V ; 5V/div : 300V |
| Bandwidth Limit | 20MHz （-3dB） |
| TRIGGER |
| Sources | CH1 , CH2 , CH3 , CH4 , Line |
| Modes | Auto-Level, AUTO, NORMAL, SINGLE,TV,Edge |
| Coupling | AC , DC , LF rej. , HF rej. , Noise rej. |
| Sensitivity | DC ~ 25MHz : Approx. 0.5div or 5mV
25MHz ~ 60MHz : Approx. 1div or 10mV |
| HORIZONTAL |
| Range | 1ns/div ~ 10s/div （1-2-5 increments）; ROLL:250ms/div ~ 10s/div |
| Modes | MAIN, WINDOW, WINDOW ZOOM, ROLL, SCAN, X-Y |
| Accuracy | ∮0.01% |
| Pre-Trigger | 20 div maximum |
| Post-Trigger | 1000 div |
| X-Y MODE |
| X-Axis Input | Channel 1 |
| Y-Axis Input | Channel 2 |
| Phase Shift | ∮3 at 100kHz |
| SIGNAL ACQUISITION |
| Real-Time Sample Rate | 1GSa/s maximum |
| Equivalent Sample Rate | 25GSa/s maximum |
| Vertical Resolution | 8 Bits |
| Record Length | 25K Dots maximum |
| Acquisition Mode | Normal, Peak Detect, Average |
| Peak Detection | 10ns |
| Average | 2 , 4 , 8 , 16 , 32 , 64 , 128 , 256 |
| CURSORS AND MEASUREMENT |
| Voltage Measurement | Vpp , Vamp , V avg , Vrms , Vhi , Vlo , Vmax , Vmin , Rise Preshoot/ Overshoot , Fall Preshoot/Overshoot |
| Time Measurement | Freq , Period , Rise Time , Fall Time ,PositiveWidth , NegativeWidth , Duty Cycle |
| Delay Measurement | Eight different delay measurement |
| Cursors Measurement | Voltage difference between cursors （V）Timedifference between cursors （T） |
| Auto Counter | Resolution : 6 digits
Accuracy : ∮2%
Signal Source: All available trigger source except theVideotrigger mode |
| CONTROL PANEL FUNCTION |
| Autoset | Adjust Vertical VOLT/DIV, HorizontalTIME/DIV,and Trigger level automatically |
| Save Setup | Up to 20 sets of measurement conditions |
| Save Waveform | 24 sets of waveform |
| DISPLAY |
| TFT LCD Type | 5.6 inch |
| Display Resolution | 234 （Vertically） x 320 （Horizontally） Dots |
| Display Graticule | 8 x 10 divisions ; 8 x 12 divisions （menu off） |
| Display Brightness | Adjustable |
| INTERFACE |
| Go/NoGo Output | 5V Maximum/10mA TTL Open Collector Output |
| RS-232 Interface | DB 9-pin male DTE RS-232 interface |
| GPIB Interface （Option） | Fully programmable with IEEE 488.2 compliance |
| USB | USB Host/Device 2.0 full speed supported |
| POWER SOURCE |
| Line Voltage Range | AC 100V ~ 240V , 48Hz ~ 63Hz , Auto selection |
| Battery Power（Option） | Battery : 11.1V Li-Ion battery pack
Charge Time : 8 hours （Power ON）
Operating Time : 3 hours , depending on operating condition |
| MISCELLANEOUS |
Multi-Language Menu | Available |
| Online Help | Available |
| Time Clock | Time and Date, Provide the Date/Time forsaveddata |
| DIMENSIONS&WEIGHT | 254D x 142H x 310W（mm）
Approx. 4.3kg |
規格
環保在線