| 超薄型 微型光纖光譜儀 | ATP2400 |
產品概述
集20年的光纖光譜儀研制經驗，奧譜天成推出了新一代高性能超薄光纖光譜儀：ATP2400，它內置了脈沖氙燈驅動電路，采用高靈敏度線性CMOS，并特別定制了超低噪聲CMOS信號處理電路，從而大幅降低了傳感器的噪聲，獲得了的信噪比（比同類競爭對手提高了約2倍），而且提高了ATP2400的測量可靠性，測量結果不隨環境溫度變化，為業界水平。ATP2400可接收SMA905光纖輸入光或者自由空間光，通過USB2.0或者UART端口，輸出測量所得的光譜數據。
ATP2400只需要一個5V直流電源供電或者USB供電，非常便于集成使用。
| 型號 | 探測器像素 | 探測器是否制冷 |
| ATP2400 | 2048像素 | 否 |
特點：
? 體積超小、超薄、超輕；
? 光纖輸入、信號輸出，在同一側，非常便于集成
? 探測器：線性 CMOS
? 探測器像素：2048 像素
? 超低噪聲 CCD 信號處理電路
? 光譜范圍: 180-1180 nm（具體依需求而定）
? 光譜分辨率: 0.1-2 nm (取決于光譜范圍、狹縫寬度)
? 光路結構：交叉 C-T
? 內置脈沖氙燈驅動
? 積分時間：0.1ms-130s
? 供電電源：DC 5V±10% 或 USB 供電
? 16 bit, 2MHz ADC
? 光輸入接口：SMA905 或自由空間
? 數據輸出接口: USB2.0 (High speed)或 UART
? 20 針雙排可編程外擴接口
典型應用：
? 快速、超微量分光光度計；
? 環保儀器（煙氣、水質）；
? 透過率、反射率檢測；
? 光譜分析/輻射分光分析/分光光度分析
? 激光波長測定
2 Electrical Pin-out
Table 1 Electrical Characteristics
| Parameter | Min | Typ | Max | Unit |
| Power Supply | ||||
| Operating voltage range | 4.5 | 5 | 5.5 | V |
| Operating current | 250 | mA | ||
| Logic Inputs(3.3V LVTTL, Five-volt tolerant) |
| |||
| High level input voltage | 1.7 | 3.6 | V | |
| Low level input voltage | -0.3 | 1.0 | V | |
| Logic Output(3.3V LVTTL) | ||||
| High level output voltage | 2.4 | V | ||
| Low level output voltage | 0.4 | V |
The module is equipped with a 20-pin male angled box header(2x10, 2.00 mm pitch) ａnd USB2.0 C type interface. The 20-pin connector is a Samtec part # STMM-110-02-L-D-RA connector. The mate to this is a Samtec part # TCSD-10-D-XX.XX-01-N.
Table 2 Electrical Pin-Out
| Pin# | Description | I/O | Function Description |
| 1 | VCC | / | Power Supply, 5V±0.5, |
| 2 | GND | / | Ground |
| 3 | TX | Output | LVTTL Transmit signal |
| 4 | RX | Input | LVTTL Receive signal |
| 5 | Lamp Enable | Output | LVTTL output the lamp enable signal. |
| 6 | N.C. | / | / |
| 7 | Ext_trigger_in | Input | LVTTL input the trigger signal. Falling edge trigger collection |
| 8 | N.C. | / | / |
| 9 | SPI_SCK | Output | The SPI Clock signal for communications to other SPI peripherals |
| 10 | SPI_MOSI | Output | The SPI Master Out Slave In (MOSI) signal for communications to other SPI peripherals |
| 11 | SPI_MISO | Input | The SPI Master In Slave Out (MISO) signal for communications to other SPI peripherals |
| 12 | SPI_CS | Output | The SPI Chip/Device Select signal for communications to other SPI peripherals |
| 13 | GPIO0 | Input /Output | General Purpose Software Programmable Digital Inputs/Outputs, LVTTL Logic. |
| 14 | GPIO1 | Input /Output | General Purpose Software Programmable Digital Inputs/Outputs, LVTTL Logic. |
| 15 | GPIO2 | Input /Output | General Purpose Software Programmable Digital Inputs/Outputs, LVTTL Logic. |
| 16 | GPIO3 | Input /Output | General Purpose Software Programmable Digital Inputs/Outputs, LVTTL Logic. |
| 17 | GPIO4 | Input /Output | General Purpose Software Programmable Digital Inputs/Outputs, LVTTL Logic. |
| 18 | GPIO5 | Input /Output | General Purpose Software Programmable Digital Inputs/Outputs, LVTTL Logic. |
| 19 | GPIO6 | Input /Output | General Purpose Software Programmable Digital Inputs/Outputs, LVTTL Logic. |
| 20 | GPIO7 | Input /Output | General Purpose Software Programmable Digital Inputs/Outputs, LVTTL Logic. |
3 譜圖示例
圖1 ATP2400-180-410-50的分辨率測試，分辨率為0.621nm
