產品型號：JSN2901

產品名稱：鑄鋁合金腐蝕測定器JSN2901

產品說明：

JSN2901鑄鋁合金腐蝕測定器

一、符合SH/T0620標準

二、主要技術參數：

工作方式：溫控器PID控溫

控溫精度：135±0.1℃

測溫方式：高精度鉑電阻測溫

計時方式：自動計時

加熱方式：金屬鑄鋁加熱

*控溫方式：電子數顯溫控儀

功    率： 650W

工作電源： AC220V±10%  50HZ

三、性能及特點

1、本儀器采用進口高精密控溫表PID溫度控制，其溫度穩定，使用壽命長；

2、儀器采用進口高精度鉑電阻測溫，采用高精密度的溫度數顯儀對試樣溫度控制，精確可達0.1℃；

3、本儀器采用金屬浴代替水浴或油浴，克服了大氣壓給溫度帶來的影響。在試驗完畢后，能自動關閉加熱系統，節約能源；

4、本儀器在斷電后再次恢復運行時，儀器將自動恢復計時，為操作者提供方便，節省時間。

JSN2901 cast aluminum alloy corrosion tester

I. It conforms to SH/T0620 standard

Ii. Main Technical parameters:

Operating mode: Temperature controller PID temperature control

Temperature control accuracy: 135±0.1℃

Temperature measurement: high precision platinum resistance temperature measurement

Timing: Automatic timing

Heating method: Metal casting aluminum heating

* Temperature control mode: electronic digital display temperature controller

Power: 650 w

Power supply: AC220V±10% 50HZ

Iii. Performance and Characteristics

1, the instrument adopts imported high precision temperature control table PID temperature control, its temperature stability, long service life;

2. The temperature is measured by imported high-precision platinum resistance and controlled by high-precision temperature digital display instrument, which is accurate up to 0.1℃;

3. The instrument adopts metal bath instead of water bath or oil bath, which overcomes the influence of atmospheric pressure on temperature. After the test, the heating system can be shut down automatically to save energy.

4. When the instrument resumes operation again after power failure, the instrument will automatically resume timing to provide convenience for the operator and save time.