武研銷售WRY系列/臨沂萊蕪+常州市武研熱油泵有限公司+WRY系列常州武進高溫導熱油泵要預熱的原因有：

（1）溫度高

(1) high temperature

熱油泵一般溫度在200～350℃左右，如不預熱，泵體涼，熱油進入后，因冷熱差異大，食使泵經受不住這種劇烈的變化，引起泄漏、裂縫、部件受損和零件因熱脹系數不一樣，而使兩個零件脹住等等。

The general temperature of hot oil pump in the 200 ~ 350 DEG C, such as preheating, pump body cool, into the hot oil, because of the differences of heat and cold, eat the pump could not withstand such drastic changes, causing leakage, cracks, damaged parts and components by the coefficient of thermal expansion is not the same, and the two parts bulging live and so on.

（2）粘度大

(2) viscosity

熱油泵輸送的介質粘度都較大，在常溫下和低溫下會凝固，甚至把泵體管線凝死，而造成啟動不上量，流量、揚程小，并會使泵產生振動和雜音。

Heat pump transmission medium viscosity are larger, at room temperature and low temperature will be solidified, and even the pump pipe line to die, and cause no amount of start-up, flow, head small, and will make the pump vibration and noise.

地 址：常州市武進區洛陽鎮虞橋章家頭50-1號（村委斜對面）
銷 售：,
售 后：
傳 真：
手 機：
: 876363125
郵 箱：WRY@vip.163.com
熱油泵配件：www.wry006。。ｃｏｍ 
WRY熱油泵：www.wry002。。ｃｏｍ 
WRY導熱油泵：www.wry008。。ｃｏｍ
離心式熱油泵：www.wry003。。ｃｏｍ 
友情鏈接：武研熱油泵 www.wyryb。。ｃｏｍ
爐排減速機：www.whboiler。。ｃｏｍ
鍋爐除渣機：www.glfj。。ｎｅｔ
被動爐排片：www.cz-boiler。。ｃｏｍ.cn

2016.6.27韓